benoit26
First Lieutenant  Posts: 1 Registered: 8/27/2007 Status: Offline
|
posted on 8/27/2007 at 21:51 |
hi , i have a 2 watt handbuild hi gain TUBE amp . its output is 8 ohm
impedence . its a line out for running 8 ohm cabinet .
i was wondering if i could plug headphone into this ???? most heapdhone
nowadays are like 32 ohm or over . Any chance of blowing my output
transformer ???
i also check ebay and i saw 8 ohm headphone ( vintage from the 70/80s ) but
those are STEREO heapdhone . woudl that be a problem . arent guitar amp
MONO .
** i heard all type of answer yet : doesnt matter , doesnt matter casue its
not enough power to blow the transformer , its very important .etc...
id like really to get a good answer .
thank you guys .
i just dont want to blow out my transformer or my whole amp . thank you .
[Edited on 8/28/2007 by benoit26]
[Edited on 29/8/2007 by moderator]
|
| |
Telefreak
Moderator   Posts: 440 Registered: 1/12/2004 Status: Offline |
posted on 8/28/2007 at 07:44, Reply 1 |
| The only problem with plugging those 8 ohm headphones in would be that the
sound will only come out of one earpiece ____________________
Technology, not technique
|
| |
kc5jk
First Lieutenant Posts: 6 Registered: 8/31/2007 Status: Offline |
posted on 9/2/2007 at 08:48, Reply 2 |
Not to worry. Almost any headphones with impedence lower than 600-ohms
will work. In the case of stero phones, they can be modified for both
stereo and monaural, by adding a small SPST (3-pin) switch, as follows:
X---to tip of plug (for mono)
X---from headphone wire which was connected to ring
X---to ring (for stereo)
If you don't want to modify the phones, you can add a stereo headphone jack
to the amp, wired to feed the mono amplifier output to both ring and tip
terminals (resulting in mono operation when stereo phones are plugged into
it).
Paul www.KC5JK.com "New Twang Page"
|
| |
